Posted on Leave a comment

First Molar Crown With Medit i500 Version 2.1 Beta, Design In exocad, And Milled With Imes Icore Cortitec One

margin market medit i500 2.1

Case Set Up

In this video we showcase the set up page of the Medit i500 Lab Version for software version 2.1, where you define the job description, enter parameters, designate the opposing and proceed to the next step where you launch the imaging software.

video

 

Pre-Op Documentation for Full Cuspal Coverage

This footage was taken to document the undermined cusps and the justification for full cuspal coverage

video

Captured Impressions While Patient Was Reaching Anesthesia
While the patient was reaching anesthesia, the opposing arch was captured along with the preparation model. The area to be prepared was cropped out and once enough reduction was achieved the bite was captured.  We highly recommend that you verify reduction and adequate clearance before you capture the final preparation. This way, you have one last ditched effort to verified you will have adequate thickness to your restorative material.

video

Impression of Preparation after Reduction was Verified

video

Margins Placed in Native Imaging Software

video

Separate Design in exocad

video

Post Op

Immediate Post Op