Keep The CORiTEC ONE Spray Channels Clean

All milling machines have guidelines for proper cleaning and maintanance. The imes icore CORITEC ONE’s spray channels must be kept clean, otherwise they will spray off the target block materials. Essentially you will dry mill ceramic which will damage the material and break the drills very quickly.

You can see how little particles of ceramic and titanium dust can clog the lines.

Here we just used an ortho plier and orthowires to unclog the lines. It’s easiest to have the water spraying so you can identify the channels and see the immediate results.

keep irrigation lines clear

Link

Embed

Copy and paste this HTML code into your webpage to embed.

00:00

00:00

When cleaned and clear make sure the water it sprayed on tip of the drill from all channels.

Link

Embed

Copy and paste this HTML code into your webpage to embed.

00:00

00:00

Related

Premolar Crown with Medit i500, Meditlink, exocad, Amber Mill Block, Coritec One by Imes Icore, and Millbox CAM Software

In this clinical case a patient lost a pre-existing crown. The remaining tooth structure had recurrent decay and a new crown was warranted. After anesthesia was administered, the clearance from opposing dentition was assessed. The preparation was reduced to accommodate the necessary thickness of the material. Once adequate clearance was…

January 28, 2020

In "CORiTECT ONE by Imes Icore"

EZ Medit Scan to CAD Design to 3 Different Milling Machines

In this case demonstration, we show how you can image in the Medit i500 and follow the most logical steps and sequences to produce a restoration.  You capture the preparation, the opposing and bite and once the models are rendered, you can launch the CAD software of your choice.  The…

July 29, 2019

In "CAD/CAM"

Custom Abutment And Crown Designs Milled With Multiple Milling Machines

With the Meditlink software you can design a case and then export the designs and take them to any milling machine of your choice.  In this demonstration, we use the CORiTEC ONE to mill out the metal abutment in 45 minutes. This procedure is not intended to be a single…

August 7, 2019

In "CAD/CAM"